First off, European crystal chandeliers are basically purchased in the past few years!
The European crystal chandelier is probably dating from the past few years It’s likely to need some sort of cleaning.
Cleaning a chandelier made of crystal is one of them.
The chandelier consists of pendants. This means that the crystal ball accounts for an enviable portion. How do you remove crystal balls? It’s a bit of a challenge!
It’s harder to operate a lamp that has several crystal balls.
Prior to hanging the crystal ball, everything must be cleaned and dismantled. The small accessories on the original pendant must be bought online. Buy it now!
After you purchase, it’s somewhat more difficult to hang them individually at the time you want to return!
If you buy an entirely new model, the problem can be solved and it will be much more convenient!
If you’ve got the funds and funds, you can think about doing these things according to your specific situation.
It’s easy to solve this one. Remove the cover and rub the crystal onto the ball and you will be able to find the solution.
It’s quite a complex thing. It is advised to send a picture so that we can give you a precise response.
Crystal chandelier repair
My neighbor’s European crystal chandeliers didn’t light up at all. It was just an assortment of glass balls. They said I had bought it for more than 1,000 yuan.
I inquired if it could be fixed, and which is why I asked my neighbor to take it apart and have a look.
The interior is not so attractive as the outside.
A collection of LED lamp beads are connected in series. A switch controls whether the LED lights up or the bulb is lit up or they light up together and also an LED driver.
He tried each LED lamp’s beads with an adjustable power supply. Seven or eight didn’t work and he advised him to replace the lamp’s beads (the pins were embroider by the seller as a present, and were scratched to make them brighter).
The switch was removed and I thoroughly examined it. There was no indication that the switch was burned.
Since it’s a switch so I opted to bypass the experiment first and connected both circuits to the mains. Both the lightbulb and LEDs could be lit. The switch appears to be the only thing that is wrong.
The switch was like it from the outside.
It doesn’t look like there is any evidence of any fires inside.
Using tc2608, I searched the Datasheet and the typical circuit on the Internet using the following keywords:
I hooked it up to 220V to test, and it did not sound like in the online scenario. So I tested the relay without power and applied 12v power. It was found that it was able to be shut. The relay appears to be working.
According to the circuit, we know that by bypassing C1 and adding 12 volt DC it is possible to test the DC situation of the complete circuit. This is why we switched power to the bridge to c1 and saw that the relay can also be shut. One could speculate that the c1 relay is damaged.
Tests conducted online revealed that the bridge’s capacity was not correct.
I removed it from the unit and tried to test it offline however it wasn’t working properly either.
The range of capacitances that the multimeter can measure is also the same
I put it in place using one I found in my parts box. It was small and I wasn’t sure how it would perform.
Connect it to 220v and then check it. The relay is able to be shut down. The lamp is fixed after putting the relay back.